LE AYUDARA A ALIVIAR..

ACCESORIES & PARTS

ACCESORIES & PARTS
LUISCHIURLIZA@YAHOO.COM

Wednesday, September 14, 2011

MAZDA PARTS -----> LUISCHIURLIZA@YAHOO.COM
























Remote Keyless entry system Will not unlock
Doors
If you encounter a concern regarding doors not
unlocking when using the Remote Keyless Entry System, check
for possible installation of aftermarket LED light bulbs. These
bulbs may produce electrical noise that may interfere with the
operation of the Remote Keyless Entry System.
If you determine the Remote Keyless Entry System door unlock
malfunction is caused by an aftermarket accessory,
do not attempt any repairs to the vehicle.

Multi model
PCM Reprogramming failure
If PCM reprogramming is required, follow the procedure below. PCM may be blanked if the procedure below is not followed.
PCM Reprogramming Procedure
1. Reboot IDS to clear memory before reprogramming.
2. Using current IDS software, reprogram the PCM to the latest calibration by following the “Module Reprogramming”
procedure.
NOTES:
Always update the IDS tool fi rst, then follow on-screen instructions to download the needed calibration fi le for
PCM reprogramming.
It is not necessary to remove any fuses or relays during PCM reprogramming when the IDS screen prompts you
to do so. You may accidentally stop power to one of the PCM terminals and cause the PCM to be blanked, or you
may receive error messages during the IDS reprogramming procedure.
IDS shows the calibration part numbers after programming the PCM.
PCM calibration part numbers and fi le names listed in any Service
Bulletin may change due to future releases of IDS software, and
additional revisions may be made to those calibrations for service
related concerns.
When reprogramming a PCM, IDS will always display the “latest”
calibration P/N available for that vehicle. If any calibration has
been revised/updated to contain new information for a new
service concern/issue, it will also contain all previously released
calibrations.
When performing this procedure, we recommend
using the “Power Supply” mode in the Battery
Management System to keep the vehicle battery
up to capacity. If a different charger is used, make
sure it does not exceed 20 AMPS. If it exceeds 20
AMPS, it could damage the VCM.
After performing the PCM Reprogramming Procedure, verify the
repair by starting the engine and making sure there are no MIL
illumination or abnormal warning lights present.
NOTES:
If any DTCs remain after performing DTC erase, diagnose the DTCs according to the appropriate Troubleshooting
section of the Workshop Manual.

After PCM reprogramming, it is no longer necessary to road test the vehicle to “relearn” KAM (Keep Alive Memory).

I hope it can help you.

Submit your own M-Tip Article!
If you have a valuable repair tip that you would like to submit for
consideration in the next M-Tips Newsletter, please send by e-mail to
LuisChiurliza@YAHOO.com


RX8
VIDEO!



FOTO :





Muy buen producto!!





Shop Amazon - Camera, Photo, and Video--New from 2012 CES













Leave a comment

Total Pageviews

Oportunidad!